Hello all,

I'm doing an electric analysis coupled with a thermal-transient analysis with Workbench 18.1. I have a coil where I set a voltage at one end and then simulate the thermal heating. My problem is, that my electric analysis is independent from my thermal-transient analysis, so there is no influence on the resistance. The resistance stays the same throughout my simulation and the end temperature is too high. 

I want to ask, if there is a possibility to couple my results from the thermal-transient analysis back to my electrical? I tried it with a snippet, but the results are the same. Maybe I didn't placed it correctly or something is missing. I'm new to Ansys.

I need help. Please

And thank you