Error While Using UDF in Parallel FLUENT

  • 51 Views
  • Last Post 2 weeks ago
Wantedmania89 posted this 3 weeks ago

Hi Everyone,

I'm currently running a transient simulation of air and SF6 flow in an aircraft cabin model on FLUENT (ANSYS V.18.2). Although the case runs smoothly on many mesh configurations, either for the steady or transient modes, without a UDF, when I try to initialize the solution after interpreting the UDF shown below and using it as a velocity inlet profile at one zone on the parallel mode, FLUENT crashes after giving me the following error:

Received signal SIGSEGV.

MPI Application rank 0 exited before MPI_Finalize() with status 2

However, when I switch FLUENT to the serial mode, the solution initialization process goes by fine, and I could run the case for some iterations.

My question is: is there any way I can fix this problem and do parallel simulation for my case using this UDF? 

 

THE UDF CODE I INTERPRETTED:

 

#include "udf.h"

DEFINE_PROFILE(velocity_magnitude, thread, position)

{

  double M, time, velocity_inj, CPFR, PVT, tau, a1, a2, b1, b2, c1, c2, A, gender, CEV, flowrate;

  double gamma1, gamma2;

  face_t f;

  PVT = 0.0664;

  CEV = 2.5;

  gender=1.0;

  A=0.0000396;

  time = 1.0;

  tau = time/PVT;

  if (gender == 1.0)

  CPFR = (CEV-2.4448)/0.138;  /* originally (CEV-0.2983)/0.138 */

  else

        CPFR = (CEV+0.043)/0.204;

  a1 = 1.680;

  b1 = 3.338;

  c1 = 0.428;

  a2 = (CEV/(PVT*CPFR))-a1;

  b2 = ((-2.158*CEV)/(PVT*CPFR))+10.457;

  c2 = 1.8/(b2-1);

  gamma1=2.792;

  if (CEV==0.5)

  gamma2=2.13;

  else if (CEV==2.5) /* Use this and adjust the CPFR equation above accordingly to get CPFR = 0.4 l/s */

gamma2=836.8;

  else if (CEV==5.0)

gamma2=1247.28;

  if (tau <= 1.2)

  M=(a1*pow(tau,b1-1)*exp(-tau/c1))/(gamma1*pow(c1,b1));

  else

  M=(a1*pow(tau,b1-1)*exp(-tau/c1))/(gamma1*pow(c1,b1))+(a2*pow(tau-1.2,b2-1)*exp(-(tau-1.2)/c2))/(gamma2*pow(c2,b2));

  flowrate=0.001*M*CPFR;

  velocity_inj = flowrate/A;

  F_PROFILE(f, thread, position) = velocity_inj;

 

}

 

Order By: Standard | Newest | Votes
Raef.Kobeissi posted this 2 weeks ago

After you interpreted it did you try to hook the udf again using parallel processing?

Raef Kobeissi

Wantedmania89 posted this 2 weeks ago

Hi Raef,

Yes, that's exactly what I did, but Fluent crashed with the error above.

Thanks

Close