I am unable to mesh on the new model (after topology optimization) due to poor quality of the elements, I have tried meshing using very small element sizes without any success.

My current standard of procedure after topology optimization is as follows :

1. Insert a plane then extract curves

2. Fill Geometry and pull surface to the initial thickness of the geometry

3. Suppress previous solids.

**It is necessary to do this every single time in order to successfully mesh over the model?**

A side question, anyone has any help documentation for ANSYS regarding topology optimization? I'm unable to find any.

Thank you for your attention and time. (I have attached an image showing what happens if you do not fix the geometry)