analysis settings transient thermal

  • 89 Views
  • Last Post 03 March 2020
  • Topic Is Solved
Wasif posted this 06 February 2020

I want to run a transient simulation starting from 1 second till 1000s. for eg. I want to read the temperature at each second till the 1000 second. I do not want to read the temperature at the values in between each second. as an example

 

1s 20degrees

2s 21degress

3s 22degress

 

What will be the settings in this case. It is confusing in the analysis settings

Order By: Standard | Newest | Votes
peteroznewman posted this 06 February 2020

One way to force the system to deliver exactly 1000 temperature results at 1 second intervals is to turn off Auto Time Stepping.

Turning off Auto Time Stepping might cause difficulty converging.

I don't understand why you must have results only on the 1 second mark.

 

  • Liked by
  • ANKIT123
CalcM posted this 11 February 2020

I am unable to change stel end time, whatever I type it resets to default 1

Melvinga24 posted this 03 March 2020

IT  WILL CHANGE 

FOR THAT CHANGE THE CURRENT STEP NUMBER TO END STEP 

EXAMPLE - IF YOU HAVE 3 STEP, U WANT TO GIVE END TIME VALUE TO THE THIRD STEP THEN CHANGE THE CURRENT STEP NUMBER TO 3

Close