Angular deformation

  • 118 Views
  • Last Post 26 April 2019
  • Topic Is Solved
kiranhr posted this 06 April 2019

I have modelled a composite shaft with 15 layers of glass fiber and applied a torque of 400Nm  on one end with fixity at the other end. I have done the same modelling in APDL  and I have obtained an angular deformation of about 0.1202rad. But in workbench(ACP) I am not getting the result correctly? Also I would like to know how to extract angular deformation in workbench?

Result image

Stack up

 

Order By: Standard | Newest | Votes
peteroznewman posted this 07 April 2019

Use a Flexible Rotation Probe on the edge.

kiranhr posted this 26 April 2019

I am not getting how to use the flexible rotation probe. If you have any resources or examples regarding the same would help a lot.

kiranhr posted this 26 April 2019

What I came to know through internet is along with flexible rotation probe, few APDL commands should also be used to extract angular rotation. Is it the case, that should we use flexible rotation command?

Any resources or video regarding the same will be of greatest help.

Regards,

Kiranhr

Close