ANSYS Additive Help

  • 130 Views
  • Last Post 27 February 2019
TSlagle posted this 26 February 2019

 Hello everyone,

I am attempting to use the additive system in the workbench to simulate a part being printed directly onto the bed. However, after I use the wizard I get this error (see image). I cannot figure out how to fix it!

Error I am getting

 

SandeepMedikonda posted this 27 February 2019

Hi,

This is just a warning. at it refers to the temperatures at which your CTE's have been input in Engineering Data and the melting temperature you are specifying here.

The error seems to something else, look in your solver output under solution information. I feel like the problem is because of the version you are running, additive licenses were not available in v19.2. If that is the case, try upgrading to v2019R1.

Regards,
Sandeep
Guidelines on the Student Community

Close