Beams, Shells and Bonded Contact

  • 487 Views
  • Last Post 21 October 2019
peteroznewman posted this 06 September 2019

Attached Files

  • Liked by
  • chandramouli
Order By: Standard | Newest | Votes
chandramouli posted this 23 September 2019

Hello peteroznewman,

The pinball size should be 4mm I think ,because if we keep it at 12mm it attaches to the nearby holes(that is what happened when I tried).

4mm seems to be sufficient enough to connect with the nodes.

Though the results were pretty similar with just 1mpa stress higher and .04mm difference in deflection.

 

peteroznewman posted this 23 September 2019

Hello chandramouli,

Thanks for the comment. It's always good to verify model inputs and test the limits.

Regards,
Peter

  • Liked by
  • chandramouli
chandramouli posted this 21 October 2019

Hello peteroznewman,

Why did you use MPC formulation instead of the beam formulation?

Can you please enlighten me what the difference between the selection would have been?

Close