Catheter Geometry Design DoE

  • Last Post 29 March 2019
zjuv9021 posted this 27 March 2019

Hi all,

I'm looking to have inputs of different catheter geometries that are significantly different an therefore are set up as new components within Spaceclaim:

How can I set these separate geometries up as input parameters to perform a DoE and corresponding response surface?

Kind Regards,



SandeepMedikonda posted this 29 March 2019

If you are talking about parametrizing the dimensions such as rounds, holes, lengths etc. you can use groups and dimensions in SpaceClaim.

If you are talking about replacing entire geometries, you would have to use ACT scripting.