Conformal mesh

  • Last Post 10 February 2019
  • Topic Is Solved
Mohamed Abu-bakr posted this 08 February 2019

I am meshing a simple pipe using Ansys meshing but I couldn't achieve conformal mesh at the interface between the fluid and solid domains as shown in figure especially when I use inflation


Order By: Standard | Newest | Votes
Mohamed Abu-bakr posted this 10 February 2019

Thank you

peteroznewman posted this 09 February 2019

In SpaceClaim, select the name at the top of the outline and in the Properties window is Share Topology which is set to none.  Set that to Share.  Then close SpaceClaim, Refresh the Project and open Meshing  (Mechanical is where you mesh Structural models, Meshing is where you mesh CFD models, it the same interface).

Mohamed Abu-bakr posted this 08 February 2019

I am using  SpaceClaim. Also, I am doing CFD simulation so what do you mean by Mechanical module?

sathya posted this 08 February 2019

Hi, In Design modeller select two bodies and form a new part. Then bring it to mechanical module and mesh it.