I'm tryng to model a fluid disk and i need to separate it in smaller disks for improving the mesh.
Firstly I created the whole disk body in designmodeler, frozen it and than I separated it by the "slice by plane" function, created the mesh and went to FLUENT for the computation. At this point I have a problem due to the presence of two "wall" at the two disks interface of the separation zone in the "Bonduary Condition" section.
I think the problem is in the "connections" section of the "Meshing" editor.
How can I remove these wall's, or how can I give continuity to the fluid body?
Thank you all