conversion of solid into surface during using merge of surfaces tool ?

  • 170 Views
  • Last Post 09 April 2018
maurya posted this 09 April 2018

hello Peter sir 

                         during merge faces  tool,  solid body is converting into surface body. 

i am attaching video it will clear you the problem.

at 1:26 solid body converted into surface

thanks

Order By: Standard | Newest | Votes
peteroznewman posted this 09 April 2018

Hello Deepak,

If you zoom in, is it possible that a tiny sliver face was left unselected?  I found the selection tool could miss a small face.

Show me what is on your Facets tab.  Do you have Skin Surface?  That may be more robust at covering the geometry with simple faces. 

Regards,
Peter

maurya posted this 09 April 2018

hello sir 

               sorry i forget to attached the model.

below is the image of facet tab

.

yes skin surface is available in insert tool but it works only for .stl file, i think merging face may be simpler after this i will try skin surface.

thank you

Attached Files

maurya posted this 09 April 2018

hello sir 

           this is new video with zoom so that it confirm that no triangle should left.

 

still problem is there

thank you

peteroznewman posted this 09 April 2018

Zoom in more, especially on the bottom edge. 

I see in Facets, they have Shrinkwrap. That could be good. I don't have that l license. But you say you have to start with STL faces...

Close