Error

  • 22 Views
  • Last Post 09 August 2019
CFDmukesh0223 posted this 09 August 2019

Hi Everyone,

I am doing simulation of two phase flow in Circular Geomerty. With one inlet surface for water and air inlet from other surface section. I am facing divergence issue after 1.5s of simulation.  Is is due to meshing? Though I have mesh with hexa. Also check Mesh quality which detail are in pic. Please give some suggestions on this. Thanks alot. 

abenhadj posted this 09 August 2019

The two metrics are okay but I would look into cell volume change and skewness too (set mesh check verbosity to 2). I think that we need to check other things, though.

Add details about models used, phase interaction, phases,...

Best regards,

Amine

Close