Floating point exception in a FSI simulation

  • Last Post 08 July 2019
oierelosegi97 posted this 08 July 2019



I´m a Spanish student who is trying to make an FSI simulation. I´ve been trying for a while this type of simulations but I haven´t achieved doing it for a geometry that looks like a balloon. I think that ANSYS is not remeshing my fluid. I always reach to the floating point exception error. Any help please?


In the following link you can see my files:



Thank you,



oierelosegi97 posted this 08 July 2019

I´ve tried doing it with very small loads and it worked! But I need it with quite big loads to see the reactions when it deforms quite a lot.