Floating point exception in a FSI simulation

  • 34 Views
  • Last Post 08 July 2019
oierelosegi97 posted this 08 July 2019

 Hello,

 

I´m a Spanish student who is trying to make an FSI simulation. I´ve been trying for a while this type of simulations but I haven´t achieved doing it for a geometry that looks like a balloon. I think that ANSYS is not remeshing my fluid. I always reach to the floating point exception error. Any help please?

 

In the following link you can see my files:

https://drive.google.com/drive/folders/1DFWnn8PKTLnMKMMfsl4FIzZ_34acI-IM?usp=sharing

 

Thank you,

 

Oier

oierelosegi97 posted this 08 July 2019

I´ve tried doing it with very small loads and it worked! But I need it with quite big loads to see the reactions when it deforms quite a lot.

Close