I have formed some specific faces on surface bodies in Spaceclaim , where I want to put thermal loads on afterwards in the setup.
But my model is a composite structure and I want to see the temperature plot on each ply, so I use ACP Pre, create a solid model and then link it to a stady state thermal analysis.
The thing is that after opening the model in the thermal analysis mechanical, the faces I made in Spaceclaim, are not there , so I cannot choose the specific area to apply the load on.
The same thing happens after having set a symmetry before the ACP Pre, the symmetry is not transfered afterwards in the mechanical in a static structural analysis, and I can also not set it there (inside the mechanical).
Is there something I can do to transfer these features after using ACP Pre?