Hi, is there any option how I could restrict the angle of these two lines in the picture below in the DesignModeler?

I looked at the forced conditions but I don't find anything.

The angle shouldn't be less than 180°.

Thank you.

- 26 Views
- Last Post 19 January 2020

Mike95
posted this
18 January 2020

Hi, is there any option how I could restrict the angle of these two lines in the picture below in the DesignModeler?

I looked at the forced conditions but I don't find anything.

The angle shouldn't be less than 180°.

Thank you.

peteroznewman
posted this
19 January 2020

Dimension the angle and don't enter numbers less than 180. Maybe the dimension will end up on the opposite side and then don't enter numbers larger than 180.

Mike95
posted this
19 January 2020

The angle depends on the other five parameters. That's why I can't dimension the angle.

peteroznewman
posted this
19 January 2020
- Last edited 19 January 2020

Delete other dimensions so that you can dimension the angle.

Or, write equations for other dimensions that limit the angle to be greater than 180.

- peteroznewman 169
- Kremella 106
- Aniket 79
- rwoolhou 77
- Wenlong 57
- Kalyan Goparaju 50
- abenhadj 47
- HollyFart 42
- Chand 27
- rahkumar 25

rajaumer14342 is a new member in the forum

AmandaKate001 is a new member in the forum

hezronelyakim is a new member in the forum

MohAgha1 has been awarded the Favourited Post badge

MohAgha1 has been awarded the First Favourite badge