Hi, is there any option how I could restrict the angle of these two lines in the picture below in the DesignModeler?

I looked at the forced conditions but I don't find anything.

The angle shouldn't be less than 180°.

Thank you.

- 26 Views
- Last Post 19 January 2020

Mike95
posted this
18 January 2020

Hi, is there any option how I could restrict the angle of these two lines in the picture below in the DesignModeler?

I looked at the forced conditions but I don't find anything.

The angle shouldn't be less than 180°.

Thank you.

peteroznewman
posted this
19 January 2020

Dimension the angle and don't enter numbers less than 180. Maybe the dimension will end up on the opposite side and then don't enter numbers larger than 180.

Mike95
posted this
19 January 2020

The angle depends on the other five parameters. That's why I can't dimension the angle.

peteroznewman
posted this
19 January 2020
- Last edited 19 January 2020

Delete other dimensions so that you can dimension the angle.

Or, write equations for other dimensions that limit the angle to be greater than 180.

- peteroznewman 177
- abenhadj 144
- Kremella 102
- Aniket 95
- tsiriaks 43
- Wenlong 34
- Mahesh11 30
- Kalyan Goparaju 30
- rwoolhou 29
- kkanade 28

sitota is a new member in the forum

Daming206 is a new member in the forum

skymoon6761 is a new member in the forum

Bansal123 is a new member in the forum

JulianMarsano has been awarded the Your Question Solved badge