How do i get/extract the underlying APDL commands used in ANSYS Mechanical?

  • 179 Views
  • Last Post 20 December 2018
timlim123 posted this 19 December 2018

I have tried doing ( Tools > Write Input Files) but the commands given in the text file is an oversimplified version. The image of the text file given to me after doing topology optimization:

 

 

I have highlighted the "commands" used for the response constraint that I have set up in ANSYS Mechanical, it is a pseudo-code as there are no such APDL commands available. I really hope that there is a method to see the actual APDL Commands used so that I can possibly make my own response constraint.

 

 

Order By: Standard | Newest | Votes
SandeepMedikonda posted this 19 December 2018

Hi Tim,

I don't think there is any way to do this with APDL commands.  A long time back (probably v12.1 or so) the topology optimization commands were part of APDL but were very limited.  TOPDEF would define some of the setup, TOPEXE would run a single step of topology optimization, and TOPITER would run a series of topo iterations.  

All of the constraints were controlled with a bunch of OP commands (OPADD, OPVAR, OPTYPE, OPFRST, etc).  You can find some of the old documentation.

At some point, all of these commands became undocumented and were removed from the APDL GUI interface.  

The new Workbench Topo Opt doesn't seem to use any of those commands.  When I look at the ds.dat file it appears that all of the topo opt stuff is being handled by an APDL system command:

/SYS,"C:\Program Files\ANSYS Inc\v192\ANSYS\bin\winx64\Opti.exe" 53795 TOPO1

I'm not sure what that Opti.exe command will call but unless it specifically references the APDL commands, there isn't really a way to customize it.  

Regards,
Sandeep

  • Liked by
  • timlim123
timlim123 posted this 20 December 2018

Hi Sandeep,

Thank you for taking your time out for answering my question.

 

Would there be any method to extract the log file from ANSYS Mechanical? Maybe if I can get my hands on the log file, I will be able to see the APDL commands used for the response constraint in ANSYS Mechanical. I will take a look at OP commands to see whether are there any methods for executing response constraints.

 

Close