How to draw and define non-merge line on the fluent mesher software ?

  • 20 Views
  • Last Post 2 weeks ago
  • Topic Is Solved
Jamessmp23 posted this 3 weeks ago

Hi, I would like to know how to draw and define non-merge line on the fluent mesher software [Q - meshing ANSYS AUTODYN PrepPost] ?

I tried to define the line in the middle section that I drew separately, but when I change it to 3D mode to go next step to the meshing procedure the line is auto merge.

Any advice ? 

*When it's in the sketch mode you can see that the line is separate as picture 1.
I draw a geometry on the spaceclaim and use the fluent mesher.

Thank you,
Sumit

 

Order By: Standard | Newest | Votes
rwoolhou posted this 3 weeks ago

When you do the extrude operation there's an option to Merge Topology - make sure that's set as No. 

  • Liked by
  • Jamessmp23
Jamessmp23 posted this 2 weeks ago

It's a 2D geometry, didn't extrude it just draw a line. I had checked the auto-merge was untick.
*I click on the 3D mode for continuing to the next process.

I don't get your answer, could you please clarify it a bit more ?

Regards,

Sumit

rwoolhou posted this 2 weeks ago

I thought you were using DesignModeler which behaves differently. 

Having had a look the quickest way is to create the shape as you've done so. Use "split" under the Intersect panel and you should be able to split at the vertex. 

Jamessmp23 posted this 2 weeks ago

sorry for late reply, it's works. Thank you for the advice. 

Close