ICEM Mesh Lines are not running parallel to edge

104 Views
Last Post 23 October 2018

CatiaV5 posted this 22 October 2018

Hi guys,

I have the following geometry (see picture below). I have blocked it in ICEM (see also below). When I get the pre-mesh the mesh lines are running towards a point (see attached picture) instead of running parallel to the edges. I would like to sort this out but I have no idea how. Can anyone help me out please?

#Permalink
0
0
0

3 Comments

Order By: Standard | Newest | Votes

Admin

kkanade posted this 22 October 2018

Hello,

Please use edge association correctly. Also make sure that you have not merged any vertices.

Following video may help you .

Regards,

Keyur

#Permalink
0
0
0

Admin

kkanade posted this 22 October 2018

Here is link.

Regards,

Keyur

#Permalink
0
0
0

Admin

kkanade posted this 23 October 2018

Hello,

Did it help you? Are you able to get hex mesh?

Also, please like the answers which have helped you move forward and in the end, once your issue is resolved, please mark the most appropriate solution (most useful advice) as 'Is Solution'. This will help others who are using this thread to find answers to similar questions.

Regards,

Keyur