load Heat Generation TableIn Ansys APDl

  • 69 Views
  • Last Post 08 October 2018
Shaimaa posted this 06 October 2018

I want to load heat generation table in Apdl ansys with X,Y,Z,time,and heat generation value in thermal analysis,  I ask if it applicaple in ansys I know that ansysinterpolate3 D table X,Y , time and value but not sure it can do for 4 heat genration table or not.

Order By: Standard | Newest | Votes
SandeepMedikonda posted this 06 October 2018

Shaimaa, 

  Please see if this post and discussion helps. Also, see this section from the help.

Regards,
Sandeep
Best Practices to post on the Student Community

  • Liked by
  • Shaimaa
Shaimaa posted this 08 October 2018

Thanks A lot,SandeepMedikonda

I can import 2 D table but my Question if ansys can interpolate the 3d table?

SandeepMedikonda posted this 08 October 2018

Hi Shaimaa,

Check out the Basic Analysis Guide section 3.5.15 which covers 'Applying Loads using TABLE Array Parameters'.  Heat gen does support x,y,and z directions as primary variables (used for interpolation).

Regards,
Sandeep
Best Practices to post on the Student Community

Shaimaa posted this 08 October 2018

Thanks A lot,SandeepMedikonda

I don't have Ansys portable account to access Basic Analysis Guide section 3.5.15

SandeepMedikonda posted this 08 October 2018

Shaimaa, 

  What version are you using?

  Please see this post and this on how to access help if you are using 19 or above.

Regards,
Sandeep 

Shaimaa posted this 08 October 2018

version19

I use APDL ansys

Close