I modelled Nucleate flow boiling using Tutorial - Modeling Nucleate Boiling Using ANSYS FLUENT .

I calculated solution for SINGLE PHASE FLOW. Solution came similar to tutorial.

I calculated solution for TWO PHASE FLOW.  Solution is not similar to tutorial. 

I think there is a mistakes in creating below parameters  (page 16 in tutorial)

1.  Select outlet turb-kinetic-energy from the Turbulent Kinetic Energy drop-down list.

  1. Select outlet turb-diss-rate from the Turbulent Dissipation Rate drop-down list.

  2. Select the outlet velocity-magnitude from the Velocity Magnitude drop-down list.

Please anyone rectify my mistakes in creating New parameters.

I attached my GEOMETRY, MESH, SETUP files & ANSYS TUTORIAL file    

in google drive link: