The wave energy convertor rotor moves in still water. The rotor rotates around its shaft while the rotating shaft makes a circular motion. Like the earth's movement around the sun, the earth is orbital revolving and rotating. In this case, the rotor's revolution is active motion, using DEFINE_CG_MOTION, and the rotor's rotation is passive motion, using DEFINE_SDOF_PROPERTIES. However, the rotor can only add one UDF in a time as a rigid body in Dynamic Mesh Zones. Therefore, how can I achieve the rotation of the rotor around the shaft while the rotor's shaft is moving?
Moving mesh for the rotors of wave energy conversion device
- 36 Views
- Last Post 05 December 2018
If both parts freely rotate then you can do this with sliding mesh. Set the inner zone to rotate relative to the outer moving zone. The only UDF you may need is one to calculate the forces on the blade & structure to work out the rotation speed.
This may help.
If the suggestions provided, solves your issue, please mark this as 'Is Solution' to help others on forum.
If you have any specific questions, you can add more images with some description with arrows. Please note that as ANSYS employee, we can not download any attachments.
Thanks for your help. The rotation of rotor is due to push of water on the rotor. There is a little different between my case and this vedio.
Thank you!
This picture shows the rotor ,which consists of three blades, is rotating in channel (2D). The motion of rotor is using DEFINE_SDOF_PROPERTIES.
I want to monitor the parameters on the each blade of rotor. However,the surface name is "rotor", I can't monitor each blade. If I name each blade like "blade1","blade2","blade3", the releative position of each blade will be changed. Therefore, what should I do to monitor the each blade.
Search
Change Language
Categories
This Weeks High Earners
-
peteroznewman 134
-
abenhadj 73
-
rwoolhou 63
-
sooraj546 26
-
kkanade 23
-
abbas 18
-
gunjanauti 10
-
SandeepMedikonda 9
-
sathya 9
-
3enrique 8