muliphase

  • 61 Views
  • Last Post 28 June 2018
  • Topic Is Solved
ahmed335 posted this 19 June 2018

hi there;

while visualizing the contour of the multi-phase domain the inlet is the only wall which has shown this difference, however

, the interior nodes are coloured blue (indication for no multiphase or free surface detected) .

the interior nodes should be separated to two regions with two different colours !!!

what is the problem?

Attached Files

Order By: Standard | Newest | Votes
Kremella posted this 20 June 2018

Hello,

Is this right after initialization or after running the simulation? Are you using patch or UDF to initialize?

Best,

Karthik

 

  • Liked by
  • ahmed335
Raef.Kobeissi posted this 24 June 2018

Hello,

Have you run the simulation? It seems you assigned a fluid phase for the inlet but you did not patch the volume correctly. 

Raef Kobeissi

  • Liked by
  • ahmed335
ahmed335 posted this 28 June 2018

Thanks that was the mistake I haven't chosen the intialization to be flate or wavy .

Close