named selections from meshing not being sent to Polyflow Solver

  • 99 Views
  • Last Post 27 November 2017
bushrar posted this 20 November 2017

Hello,

 

On one geometry I created, two of the named selections on "Meshing" do not carry into the Polyflow solver.  I checked under the details of those Named Selections and it was already set to the default of "Send to Solver".  In addition I was even able to send them to the Fluent Solver.   So I was wondering how I can tackle this very specific Meshing-Polyflow communication problem?

 

 Thanks!

bushrar

Order By: Standard | Newest | Votes
Raef.Kobeissi posted this 24 November 2017

Hello, Can you please show a picture of the 2 selections.

Cheers

Raef Kobeissi

bushrar posted this 27 November 2017

The parts labeled 'Disk Wall' and 'Disk Inlet' do not go from 'Meshing' to 'Polyflow' solver.   

Raef.Kobeissi posted this 27 November 2017

I am not sure about polyflow but when I do it in Fluent these surfaces are considered interfaces. Bodies that share surfaces.

Raef Kobeissi

Close