named selections from meshing not being sent to Polyflow Solver

  • Last Post 27 November 2017
bushrar posted this 20 November 2017



On one geometry I created, two of the named selections on "Meshing" do not carry into the Polyflow solver.  I checked under the details of those Named Selections and it was already set to the default of "Send to Solver".  In addition I was even able to send them to the Fluent Solver.   So I was wondering how I can tackle this very specific Meshing-Polyflow communication problem?




Order By: Standard | Newest | Votes
Raef.Kobeissi posted this 24 November 2017

Hello, Can you please show a picture of the 2 selections.


Raef Kobeissi

bushrar posted this 27 November 2017

The parts labeled 'Disk Wall' and 'Disk Inlet' do not go from 'Meshing' to 'Polyflow' solver.   

Raef.Kobeissi posted this 27 November 2017

I am not sure about polyflow but when I do it in Fluent these surfaces are considered interfaces. Bodies that share surfaces.

Raef Kobeissi