No result file after calculation with polyflow

  • 158 Views
  • Last Post 29 August 2018
Jasmina92 posted this 22 August 2018

Hello,
I want to model a high viscous flow through a conical die with Polyflow. But after a short calculation there was no result available.  Has anyone ever experienced that no result file was written after a calculation?

After the complete set up I updated the solver-button (in the workbench project) and the calculation started to run. after a few minutes (maybe 2 – 3) the calculation stops without any message and a green check mark appears at all buttons.

But when I open the results there is not a single result. Also the res-file is empty.

Why doesn’t polyflow calculate anything? In other projects in the same workbench I am not having this problem.

Is there may be a setting that I can check to fix this?

Many thanks!
Jasmina

Order By: Standard | Newest | Votes
Kremella posted this 22 August 2018

Hello,

Could you please share a screenshot of your workbench page as well as your PolyFlow set-up? 

If you haven't already seen these, I strongly encourage you to visit Ansys HowToVideos page on YouTube for video tutorials on PolyFlow. I have attached a link which contains the entire playlist.

I hope this is useful.

Please add the screenshots.

Thank you.

Best Regards,

Karthik

Jasmina92 posted this 29 August 2018

Thank you very much for the link!

I try to attach the setups - which are the impotant ones?

Close