Optimization in batch mode

  • 55 Views
  • Last Post 20 July 2018
Luca posted this 19 April 2018

Hi all! 

I am trying to optimize the geometry of a microfluidic channel , fixing the pressure drop between the inlet and the outlet, using the optimization parameters. (It is only an exercise).

Can someone explain me how to start an optimization loop in a batch mode? 

(If it is possible it would be fine to see an example replied to this post)

Thanks for the attention

Luca Spigarelli

mli posted this 20 July 2018

You can use DesignXploror in Workbench. Adjoin solver in Fluent can optimize at the mesh lever.

Close