Hi Ansys Comunity

Am trying to plot a graph of contact tool results vs path points for multiple load steps (10 Load Steps >>>10 Graphs) using the following command. however I managed to get the same graph but repeated 10 times. what's wrong with the command??.

What will be the difference in the command if I want to do the following.

1. Plot the results for different Load-steps.

2. Plot the results for different Sub-steps.

Command 

!!!Here I have a number of commands to define the path...etc. 

set,first

*do,Loop,1,10

/PBC,PATH,,1 

/REPLOT 

PLPATH,FS

PLPATH,SD

plnsol,cont,SFRIC

plnsol,cont,SLIDE           

*if,Loop,lt,10,then

set,next

*endif

*enddo