Problem with streamline in CFX (results)

  • Topic Is Locked
  • 26 Views
  • Last Post 11 February 2020
Aerospace24 posted this 02 February 2020

Hi guys, I'm trying to plot streamline around my airfoil after aerodynamics analysis (inviscid) at lift coefficient =0.
I've a problem in the post-processing when i try to plot streamline around the airfoil using CFX tool (Results) of ANSYS 19 R2. I've obtained that the streamline pass through the airfoil instead of surrounding it. How can I solve the problem ?

 

Order By: Standard | Newest | Votes
abenhadj posted this 03 February 2020

Can you show velocity vectors?

Best regards, Amine

Aerospace24 posted this 03 February 2020

Hi Amine, of course!

p.s. How can I remove velocity vectors from airfoil perimeter ?

abenhadj posted this 03 February 2020

Inviscid= there is a slip at wall + no penetration. 

Best regards, Amine

Aerospace24 posted this 03 February 2020

Ok, Is this prompt to solve the streamlines problem or that one regarding the velocity vector on "perimeter"?

abenhadj posted this 03 February 2020

I do not understand your question: the suggestion to use vectors is just a workaround for you. If you think the behavior with streamlines is buggy you need to share more details about their creation and where you created the solution.

Best regards, Amine

  • Liked by
  • Aerospace24
Aerospace24 posted this 03 February 2020

I've obtained the solution using Fluent, it's an inviscid, incompressible analysis. I chose the angle of attack to obtain Cl=0(zero lift). Then I've used CFD-post for the results post-processing and there is the problem that I've showed in the first message of this discussion: streamlines passing through the airfoil.
Running other simulations, I did not have this problem. 

abenhadj posted this 03 February 2020

If the streamlines in Fluent are looking fine just use them from Fluent or do export massless particle tracks from Fluent to CFD-Post if you prefer post-processing in Fluent. Also check if you can create surface streamlines in Post, as I assume you ran it 2D in Fluent.

Best regards, Amine

Aerospace24 posted this 11 February 2020

Hi everyone! I've solved the problem using the following commands: geometry->type>surface streamline.

abenhadj posted this 11 February 2020

 Thanks for the update and sharing what worked with your case.

Best regards, Amine

  • Liked by
  • Aerospace24

Topic Is Locked

Close