Problems With Hex-Dominant Meshing of Fluid Body

  • 114 Views
  • Last Post 16 December 2017
Mr_fixit16 posted this 14 December 2017

Hello everyone,

I am looking for some help generating a good mesh and was wondering if anyone has any ideas.

Attached are screenshots of the best hex-dominant mesh i have been able to generate and the associated settings. The problem is the highly skewed elements between the fine inner mesh and the coarse outer mesh. I prefer to avoid tetrahedrons due to the large number of elements generated, however i do get a good mesh with tetrahedrons (based on skewness).

It seems to me, the mesher should generate successively smaller hexahedrons to step down to the smaller elements, but instead it generates apparently random tetrahedrons and such.

Any tips or advice here would be greatly appreciated. Thanks!

Bad Quality Mesh

Mesh Settings 1

Mesh Settings 2

Mesh Settings 3

Order By: Standard | Newest | Votes
Jimmyhan posted this 15 December 2017

I need to see total structure in order to find \where the problem comes from. By the way, I dont think hex dominant meshing is a good selection for boundary simulation.

Raef.Kobeissi posted this 16 December 2017

Why don’t use the Cut Cell mesh method and the manual sizing function?

Raef Kobeissi

Close