Problems with identifying the ultimate load of the beam
- 773 Views
- Last Post 14 July 2018
- Topic Is Solved
Put your .wbpz file (File>Arhive), in the above attached file miss "Flexural Solid Beam_files".
After I extracted the zip file contents, I found the .wbpj file inside the _files folder. I just moved it out of there and put it in a folder one level up where the _files folder was and I was able to open the project in Workbench.
From my results, the applied load is directly proportional to the deflection, where I was not able to identify the load-displacement response, yield point and ultimate capacity. Any advice and suggestion on this problem (where I can get the curve load vs deflection graph)? Thank you very much in advance for your help and time.
Thank you, Peter,
You have been so much helpful.
Previously, I have looked at that matter (using the SOLID65 element for the concrete element). But I was not able to make it. From the solution information, I realised that my concrete was using the SOLID187. Any suggestion on how to change SOLID187 to the SOLID65 element? Thank you very much in advance for your help and time.
You have to put a Command item like this under each body that is concrete.
After I have changed the concrete to SOLID65 using the command item, one problem I encounter (when solving the model). Same problem I face previously when I am using the command item. It does not allow me to change the SOLID187 to SOLID65 element (as attached below).
Is this problem due to the beam geometry? Any recommended solution? Thank you very much in advance for your help and time.
Click on Geometry and in the Details window, change Element Control to Manual.
I hope that is the same in Version 14.5 and if not, search the Help system for how to do that.
May I know the commands below is under which concrete grade? Thank you in advance and very sorry for the inconvenience.
I don't know about concrete grades. You will have to explain that.
The material properties above are Young's Modulus (Ex), Poisson Ratio (Prxy) and Density (Dens). Look in the ANSYS Help for the CONCR material model what the numbers in the tbdata mean.
Remember that Command snippets are in the units of the Project so you mustn't change the Project units after you use command snippets or you will get the wrong answer!
Thank you very much. You are the best teacher that helping me a lot.
- All Categories
- Community Rules, Guidelines, and Tips
- News & Announcements
- Student Products
- Pre and Post Processing
- Tutorials, Articles and Textbooks
- Installation and Licensing
- Physics Simulation
- Student Competition Teams
- eMasters Degree from UPM
- Site Feedback
This Weeks High Earners
- 1 Replacing 3-point bending test without the supports and loading pin ? Solid and shell
- 2 Defining mass source as mass fraction into density for species transport.
- 3 A Diffuser containing a fan inside analysis
- 4 Calculate a bubble average speed
- 5 Solid-Gas Multiphase System ERROR: Turbulent viscosity limited to viscosity ratio of 1.000000e+05