Regarding facing problem in meshing

  • 26 Views
  • Last Post 01 November 2018
Swapnil11 posted this 31 October 2018

I did my piping geometry water tight by using fill. But when I'm doing meshing then it cant happen...After while I gone through ICEM CFD in this tool meshing done when u call it into fluent then it leaves message check- verbosity .so what I have to do now???

Order By: Standard | Newest | Votes
rwoolhou posted this 31 October 2018

Please can you post some images of the geometry & mesh along with the exact error? 

kkanade posted this 01 November 2018

Are you able to read mesh in Fluent? Cay display any boundary zones in Fluent?

Before exporting from ICEM, please check the mesh and try to fix errors if any. 

Regards,

Keyur

Swapnil11 posted this 01 November 2018

I'll snd u images regarding my errors tommorow... Thanks for ur reply..

Swapnil11 posted this 01 November 2018

No. Actually mesh failed during call into fluent. No boundary zones detected..as I mention in my post it leaves the mesh failed n check verbosity... Ohk I'll try to fix error into spaceclaim n let u know. Thanks for ur suggestions.. Regards, Swapnil

Close