I am once again asking for your help that follows this topic.
So, I don't know why, the coordinates the program read (from the first notepad attached) were 100x larger than what's on the file. Is it because I used "," instead of "." ?
Therefore, I am asking if I can resize the surface automatically to what I need. If not, is there any way (before inserting the coordinate file) to limit the size of the mesh/geometry, before meshing ? These are the requirements I need to meet:
The number of points of the map in each direction is: I=199, J=269. To get a horizontal mesh, it should be defined: - Meshing limits: - xmin = -10000 - xmax = 9000 - ymin = -8800 - ymax = 10000 - Constant resolution zone (40 m resolution in x & y): - xcmin = -2000 - xcmax = 2000 - ycmin = -3000 - ycmax = 3000 - Number of knots of the mesh in each direction: - ni = 200 - nj = 270
I have another question (if needed I'll open another topic).
So, I've used combine tool to join the surfaces that were created by using blend tool to unite curves (described on the topic refered above). The finished form looks like it still detects different surfaces (pic following). Won't that be a problem when using the pull tool ? To get volume?
Sorry for the really long question. Thank you all.