Hi! I would like to set specific range of Equivalent Stress in Static Structural Analysis. I use CFD Post for analysis of aerodynamic where I can in quite simple way change range of parameters. How can I do it for structural analysis in ANSYS Mechanical?
Specifc range in results of static structural analysis in ANSYS Mechanical.
- 426 Views
- Last Post 03 May 2019
You can edit the values on the legend by typing new numbers if you want a specific color to represent a specific range of stress.
You can also use Capped Isosurface (one of the buttons on the toolbar) to hide elements that are below a specific value or above a specific value of stress.
Hi Peter,
Is it possible to edit the legend with user defined minimum and maximum value?
You can edit the values on the legend by typing new numbers if you want a specific color to represent a specific range of stress.
Yes, I can edit values, but with some restrictions:
1. The maximum value (user defined) cannot be lower than max value from the results.
2. The minimum value (user defined) cannot be higher than min value from the results.
This should help to address those 2 issues:
http://www.padtinc.com/blog/wp-content/uploads/2016/09/PADT_Mechanical_Custom_Legend_R17.pdf
Search
Change Language
Categories
This Weeks High Earners
-
peteroznewman 248
-
rwoolhou 98
-
abenhadj 81
-
tsiriaks 64
-
Aniket 40
-
parkersheaffer 22
-
madelpa 21
-
Autonewbie 16
-
Supreethm 12
-
Alex1EDP 11