my model is stuck on solving the mathematical model …… anybody has any suggestions … I could really use the help

I used 0.0001 second end time …. thanks guys

- 78 Views
- Last Post 08 August 2018

ahmed osama
posted this
07 August 2018
- Last edited 08 August 2018

my model is stuck on solving the mathematical model …… anybody has any suggestions … I could really use the help

I used 0.0001 second end time …. thanks guys

tsiriaks
posted this
07 August 2018

Hi Ahmed,

Please create a new thread under Physics Simulation --> Structural Mechanics

Then explain a little bit more details of your simulation setup.

Thank you,

Win

SandeepMedikonda
posted this
08 August 2018
- Last edited 08 August 2018

Another post from ahmed osama:

thank for your quick response ….

I am new to ansys so I am sorry I don't understand what you mean by creating new thread under physics simulation

….. I have a vehicle chassis for shell eco marathon competition and I was simulating front impact ,

and I've been trying to run this simulation for the past 3 days but it always get stuck on solving

the mathematical model... I've used all the default setting in the mesh …. and suddenly yesterday it worked

( with the same setup that I've been trying for the past 3 days ) but because of the big no. of nodes ( 294344)

it took about 5 hours and I got tired of it and cancelled it ...

today it got stuck again so I cant tell where the problem is .....

another thing my computer has 8 gb of ram and when the simulation was running it only used 20% of the cpu .....

if you have any question that would help you help me please let me know "

SandeepMedikonda
posted this
08 August 2018

Ahmed, Can you post some snapshots of the model you are working with? Like Geometry, Boundary Conditions (click on explicit dynamics in mechanical) and Analysis settings for us to debug.

This is not as big a model from what I can tell especially for the time you are running it, try clearing any generated data and solve it. Let us know if you are observing an initial time step being reported in the solver output?

Note that you can save your snapshots and post them as shown:

Regards,

Sandeep

peteroznewman
posted this
08 August 2018

Ahmed,

How many cores does you computer have? You say it was using only 20% of the CPU. The default for number of cores to use during a solution is 2 cores, so if you have 8 cores, then you would expect to see about 25% CPU utilization.

To get higher utilization, in Mechanical, Tools > Solve Process Settings > Advanced > Number of Cores and type 8 if you have 8 cores or 4 if you have 4 cores etc.

Regards,

Peter

- peteroznewman 76
- kkanade 72
- abenhadj 34
- Kremella 32
- SandeepMedikonda 22
- rwoolhou 18
- MaximeK 12
- sam.fares@newmill.com 11
- xiaofuli 10
- M.Richert 10

yanxiaoyu is a new member in the forum

sarin0711 is a new member in the forum

Prashant_1990 is a new member in the forum

M.Richert has been awarded the Your Question Solved badge

song has been awarded the Your Question Solved badge