I am using ICEM in order to generate a c mesh over aerofoil but I have problems with mesh quality and orthogonality quality. I have tried to use hexahedral smooth to make the control volumes close to aerofoil with low orthogonality quality more smoother but after using the hexahedral smooth the mesh become worse
structured c mesh over aerofoil naca0012 using ICEM
- 178 Views
- Last Post 30 October 2018
Can you please insert few images?
Also you can have a look at
The association seems to have been messed up. Could you check your associations again and then try smoothing your mesh? And could you post a screenshot of your smoothing settings?
I have attached a copy of the smooth setting I keep the default setting except for release orthogonality/initial heigh options in which the aerofoil curves are chosen.
for the association, all the curves are associated with edges
Could you attach a screenshot of your pre-smoothened mesh highlighting the region with Quality 0.66 to 0.83?
Do you have any points in your geometry? If you do, have you associated them accurately? The smoother works based on the input mesh and even the slightest disassociation will cause a lot of issues.
Could you share your workbench archive file so we could take a quick look into it?
I have attached a screen shoot for the orthogonal quality and quality criterion
this the link for icem project file
the cells with low orthogonal quality are those on the aerofoil as I am using y=6e-8 m to get yplus=1
The link you shared contains only the project file and the mesh file. Can you zip the entire folder including the .blk file in it.
I have attached the zip file and uploaded it on the same link.
- All Categories
- Community Rules, Guidelines, and Tips
- News & Announcements
- Student Products
- Pre and Post Processing
- Physics Simulation
- Tutorials, Articles and Textbooks
- Installation and Licensing
- Student Competition Teams
- eMasters Degree from UPM
- Site Feedback