Suction simulation

  • 114 Views
  • Last Post 05 April 2019
akin3rd posted this 26 March 2019

I would like to simulate the suction on an airfoil using fluent 

the airfoil diagram is shown below, there is a suction slot which the sucked air flows through that leads to the low-pressure cavity which causes the suction.

The idea is to induce high energy turbulent mixing in the boundary layer flow and delay/prevent flow separation, thereby preventing stall

How do I simulate this environment in ANSYS Fluent.

Thanks

Order By: Standard | Newest | Votes
kkanade posted this 27 March 2019

please check this

though its old, it will help you get through process. 

https://confluence.cornell.edu/display/SIMULATION/FLUENT+-+Flow+over+an+Airfoil-+Problem+Specification

 

akin3rd posted this 05 April 2019

Hello,

I don't see any tutorials on how to create suction.

I just need to know how to create a low-pressure environment in the suction cavity i.e. how do I specify boundary conditions that create a low-pressure environment?

Thanks

Close