thermal contact

  • 128 Views
  • Last Post 20 September 2018
malay_shankar posted this 19 September 2018

Attached is the slide showing the geometry. I need to know how to model thermal contact between the upper and lower plates.

Order By: Standard | Newest | Votes
Kremella posted this 20 September 2018

Hello,

Are the plates in physical contact? Or do you intend to create a contact between them? I am assimung you are going to use transient or steady state thermal? Are you trying to apply contact resistance?

Best,

Karthik

malay_shankar posted this 20 September 2018

Hi Karthik,

The plates are in physical contact at some places while there is a very very small gap at other places. It is a 2 dimensional steady state problem.

Yes, i am trying to apply contact resistance. Also need to know the approach to this problem where there is contact and no-contact both?

Close