Transient 3D Co-Simulation in Simplorer

269 Views
Last Post 13 September 2018

Sebastian posted this 15 August 2018 - Last edited 15 August 2018

Dear ANSYS Community,

I want to simulate a Transient 3D Co-Simulation between ANSYS Simplorer and Maxwell 3D. So I created a Co-Simulation in Simlprer and set up the Current Excitations and a Motion Setup. In 2d that works fine! In 3D I got the following message in Simplorer :"Simulation completed withe execution error on server.Local Machine / An external simulator couldn't be setup for simulation". When I have a look on Maxwell the following message: " Command line parameters are not valid / Simulation completed with execution error on server. Local machine"

Unfortunately the file is to big to attach it in the community.

Does anyboy have an idea what could be the problem?

Thanks a lot in advance

Sebastian

#Permalink
0
0
0

2 Comments

Order By: Standard | Newest | Votes

ANSYS

abenhadj posted this 15 August 2018

Moving this topic in the related thread

Best regards,

Amine

#Permalink
0
0
0

sidharthpunia10500@gmail.com posted this 13 September 2018

I am also struck with a similar problem.

Currently, I am trying to integrate Maxwell 3D design with circuits in Simplorer. I want to sweep some physical parameters (location) in Maxwell model, and derive power from Simplorer. Running with fixed parameters works, sweeping within Maxwell also works, but when sweeping integrated maxwell parameters in the Simplorer, it says "error on set parameter". Do you have any idea about what is happening and what is the correct way to do the sweep?