Water temperature on inlet pipe problems

  • 24 Views
  • Last Post 19 March 2019
Amrizal posted this 19 March 2019

Hi guys,

I have a problem with ansys fluent, i just simulated a thermal pipe. I already set the temperature of inlet pipe is 30C then the problem is while i open the result the temp start at about 27c. I dont know where the mistake is. Hope you guys could solve my problem.

My regards

Attached Files

abenhadj posted this 19 March 2019

Please check the area average temperature at the inlet in Fluent.

Best regards,

Amine

Close