Hi guys,
I have a problem with ansys fluent, i just simulated a thermal pipe. I already set the temperature of inlet pipe is 30C then the problem is while i open the result the temp start at about 27c. I dont know where the mistake is. Hope you guys could solve my problem.
My regards
Please check the area average temperature at the inlet in Fluent.
Best regards, Amine
peteroznewman
312
rwoolhou
119
abenhadj
103
tsiriaks
90
.jpg?width=20&crop=0,0,20,20)
Kremella
78
kkanade
75
Aniket
57
rahkumar
48
Wenlong
36
Abdulsalam
23
